321-666-4875
HomeCarbon Fiber laminateC-TEKRC LaminateShred Carbon FiberCNC3D PrintingShowcaseDistributorsContact Us
Store

CR-10/CR-10S Y Carriage
Carbon fiber Y carriage for CR-10 and CR-10S printer. This is a direct replacement for the stock carriage. No mods or special tools needed to install.
CR-10S Pro
Ender 3
Carbon fiber Y carriage for CR-10S Pro printer. This is a direct replacement for the stock carriage. No mods or special tools needed to install.
Carbon fiber Y carriage for Ender 3 printer. This is a direct replacement for the stock carriage. No mods or special tools needed to install.
 The Y carriage replacement parts reduce the weight reducing strain on the steppers and making direction changes easier, in turn creating better prints.
 Linear rail kits allow smoother movements with less maintenance. The Y carriage bearings are also spaced wider making the bed more stable than the stock bearing setup.

CR-10/CR-10S Linear Bearing Kit for Y Axis
CR-10/CR-10S Linear Bearing Kit for X Axis
This is a complete replacement for the Y carriage on the CR-10/10S. The kit includes 2 linear bearing sets (2 rails and 4 carriages) for the Y axis, carbon fiber mounts for the bearings, a new Y carriage, and all the hardware needed to install. The kit bolts directly to the extruded rails and you just reuse the belt.
This is a complete replacement for the X carriage on the CR-10/10S. The kit includes a linear bearing set (1 rail and 1 carriage), an X carriage adapter which allows you to reuse the stock X carriage, an end stop relocator, and all the hardware needed to install. The kit bolts directly to the extruded rails and you just reuse the belt.
Carbon fiber hot end tools.
These are wrenches for safely removing your nozzle. The large wrench holds the heater block and the other is for the nozzle. The nozzle wrench can accommodate two sizes, 6mm and 8mm.